Carbide Burrs - One Page Selection Guide
Industrial Quality Carbide Burrs
Use the filters below to set the parameters for the carbide burr (aka rotary file) you need. As you adjust the filters, product links will appear at the bottom of the page that match your selections.
Carbide Burrs / Rotary Files come in a variety of sizes and shapes – for selection help Click Here
Click “Reset Filters” to clear all filters. You can also reset an individual filter by selecting “Clear Selection” within that filter.
Retrieving your results - please wait
For best “Value” choose Brand Platinum Abrasives
For highest quality choose Brand Morse or Marxman
on 16/03/2022
Ken Tompson: I used this product to create countersinks in 1/8" diameter holes drilled in 416 stainless steel. The burr was mounted in a vertical mill/drill running at 1450 rpm with a very slow feed rate. The countersinks were perfect and examination of the burr under 10x magnification showed no wear whatsoever. A couple days later I (accidentally) ran the burr at 770 rpm in the same operation which resulted in minor chipping on two of the flutes. My mistake. Very happy with this product and will continue using and buying more when needed.
on 07/11/2019
bob: Works just like the ones from the tool store but at a cheaper cost for the same product as far as i am concerned.
on 07/11/2019
bob: Works just like the ones from the tool store but at a cheaper cost for the same product as far as i am concerned.
on 07/11/2019
bob: Works just like the ones from the tool store but at a cheaper cost for the same product as far as i am concerned.
on 07/11/2019
bob: Works just like the ones from the tool store but at a cheaper cost for the same product as far as i am concerned.
